GRP Fibreglass Roofing
A seamless, hard-wearing finish with no joints to fail.
About GRP fibreglass roofingOur Services
Liquid applied roofing in Stoke-on-Trent
Cold-applied coatings that seal awkward roofs seamlessly.
Liquid rubber roofing is the answer when a roof has too many awkward details for sheet materials, or when a tired flat roof needs sealing without a full strip. It is a cold-applied resin, brushed or rolled on wet, that cures into one seamless membrane bonded to the whole surface. Abbotts Flat Roofing installs liquid systems on homes and commercial buildings across Staffordshire, backed by over 15 years in the trade.
Because there are no hot works, liquid applied roofing is one of the safest ways to work on occupied buildings: schools, offices, shops and industrial units can stay open while we work above them. It also flows around pipes, upstands and rooflights, exactly where most flat roofs fail first. We are local roofers based in Staffordshire, covering Cheshire and Derbyshire as well, and every quote is free, written and carries no obligation.
Where liquid rubber roofing earns its keep
The system is simple to understand. The roof is cleaned and prepared, then the resin goes on wet with a brush or roller and cures into a fully bonded flat roof coating with no seams, no joints and no laps. Water cannot track underneath it because it is stuck to the deck across the whole area. That makes it a strong choice for roof refurbishment where the deck is sound but the surface has had its day.
At home, that means garage roofs, extensions, dormers, porches and garden rooms, especially ones cluttered with rooflights and soil pipes. On commercial buildings it comes into its own on gutters and detail work. We have relined industrial valley gutters end to end, lined parapet gutters on commercial buildings and sealed the joint lines on metal roofs where fixings and laps had started letting water in.
What a proper installation involves
Preparation decides whether a liquid roof lasts. We start by getting the surface clean, dry and sound: moss and dirt off, any wet insulation or rotten deck cut out and replaced. Cracks and open joints are treated first, and detail areas around pipes, upstands and rooflights are reinforced so the weakest points become the strongest. Skipping this stage is why cheap coating jobs fail within a couple of winters.
The resin then goes on in controlled coats, usually with a reinforcing layer bedded into the details, and each coat is checked before the next. Because it is cold applied there is no flame risk, no smell of hot bitumen through the building and no need to shut anything down. Most jobs are done in a day or two depending on size and weather, and we leave the roof and the site tidy.
Liquid roof repair or full replacement
Ponding water, blisters, cracked felt, stained ceilings and gutters that never quite dry out are the usual warning signs on a flat roof. The honest answer on repair versus replace depends on the deck. If the structure underneath is dry and solid, an overlay in liquid is often the smart move: full flat roof sealing without the cost, mess and skip hire of a strip and re-board.
If the deck is soaked or rotten, coating over it just buries the problem, and we will say so. Done properly on a sound base, a liquid system can give decades of service and can be recoated later to extend its life further, which makes it strong value over time. We install six flat roofing systems across Staffordshire, so our advice is based on what your roof needs, not the one product we sell.
Why choose liquid applied roofing?
- Seamless, fully bonded membrane with no joints to fail
- Cold applied, so no hot works on occupied buildings
- Ideal around pipes, rooflights, upstands and plant
- Refurbishes tired roofs without a full strip
- Proven on industrial valley gutters and parapet gutters
- Free written quotes and over 15 years' experience
Good to know
Liquid Applied Roofing questions, answered
Cannot see what you are after? Give us a call and we will talk it through, no pressure.
How long does liquid rubber roofing last?
It depends on the system and the thickness applied, but on a properly prepared roof you can realistically expect 20 years or more, and many systems can be recoated near the end of that period to extend the life again. Preparation matters more than the tin. A roof that is coated while damp or dirty will fail early no matter what product is used.
Can you coat over my existing flat roof instead of replacing it?
Often, yes. If the deck and insulation underneath are dry and sound, overlaying with a liquid system is a genuine roof refurbishment, not a bodge, and avoids the cost and disruption of a full strip. We check the roof first, sometimes cutting a small test section, and if the base is wet we will tell you an overlay is the wrong call.
What affects the price of a liquid roofing job?
Size is the obvious one, but detail work matters more than people expect. A plain garage roof is quick, while a roof full of pipes, rooflights and upstands takes longer to prepare and reinforce. Access, the condition of the existing surface and any deck repairs all feed into the cost. We survey the roof and give a free written quote before we start.
Do you do liquid roofing for commercial buildings?
Yes, a lot of our liquid work is commercial. Gutters are a speciality: we reline valley and parapet gutters and seal joint lines on metal roofs, all without hot works, so the building stays in use throughout. If you manage a shop, office, school or industrial unit, call 07479 664747 or email info@abbottsflatroofing.co.uk and we will come and take a look.
Need liquid applied roofing sorted?
Tell us about your roof and we will give you honest advice and a free written quote, anywhere across Staffordshire, Cheshire and Derbyshire.